This thread looks to be a little on the old side and therefore may no longer be relevant. Please see if there is a newer thread on the subject and ensure you're using the most recent build of any software if your question regards a particular product.
This thread has been locked and is no longer accepting new posts, if you have a question regarding this topic please email us at support@mindscape.co.nz
|
Put simply, we're looking to make 2D scatter chart with the origin (0,0) in the upper left, X-axis extending to the right, with the Y-axis extending downward with increasing positive values. Placing the x-axis on the top is easy, by simply setting the Placement property to "Top", but haven't been able to figure out how to reverse the Y axis. Our data in this case is measurements at a depth below the surface, so to display the data in an intuitive manner, the top of the chart should be depth = 0, counting to the maximum (positive value) depth towards the bottom of the chart. Is there a provision to count from a larger value in the lower of the chart to a smaller value in the top? Simply setting the Minimum and Maximum of the ChartAxis does not have the desired effect. |
|
|
Hello DBaker To get this effect, set the IsReversed property on the Y axis to true. This feature was added not long ago, so if you don't have this property, simply get the latest nightly build and you'll be ready to go. Jason Fauchelle |
|
|
Great, thanks! Couldn't find anything in documentation, it being a new feature explains that. Thanks again. |
|