This thread looks to be a little on the old side and therefore may no longer be relevant. Please see if there is a newer thread on the subject and ensure you're using the most recent build of any software if your question regards a particular product.
This thread has been locked and is no longer accepting new posts, if you have a question regarding this topic please email us at support@mindscape.co.nz
|
Hi guys, I just upgraded to lightspeed 3.0 and I installed it. I had not uninstalled 2.2 before installing 3.0. When I tried to add a lsmodel, it adds fine but I can't view the designer. I get the following error. The Mindscape.LightSpeed.Generator.Integration.LightSpeedModelPackage, Mindscape.LightSpeed.Generator.Integration.DslPackage, Version=1.0.0.0, Culture=neutral, PublicKeyToken=dabefdafd5f32554 ({AF67EB34-A276-4AAD-9E7A-9A672C30F1F1}) did not load because of previous errors. For assistance, contact the package vendor. To attempt to load this package again, type 'devenv /resetskippkgs' at the command prompt. I took at look in the GAC and I see three Mindscape dlls installed there... Mindscape.Lightspeed.Generator.Integration.Dsl Mindscape.Lightspeed.Generator.Integration.Dsl.Mapping Mindscape.Lightspeed.Generator.Model. I uninstalled everything mindscape (2.2 and 3.0) and reinstalled it. But I still get the same issue. I saw this issue when I noticed after upgrading to 3.0 if I made a change to the model the .cs file would not get updated. This is an urgent matter for me. Please Help! Sadia
|
|
|
|
|
Sorry to bother... but I fixed it... the resolution is in the error message itself. I should just read the whole thing ;) "To attempt to load this package again, type 'devenv /resetskippkgs' at the command prompt."
Thanks! |
|
|
|
