This thread looks to be a little on the old side and therefore may no longer be relevant. Please see if there is a newer thread on the subject and ensure you're using the most recent build of any software if your question regards a particular product.
This thread has been locked and is no longer accepting new posts, if you have a question regarding this topic please email us at support@mindscape.co.nz
|
Hi, Our situation is like this, all our nodes have a single inbound connection point. Our requirement specifies that when a connection is dropped anywhere on the node area it should auto-connect to that single inbound connection point. Basically I need to detect the drop target and see if the target is a node and if so - connect it to that single inbound connection point. What would be the best way to achieve that? Thanx, Gili |
|
|
Hi Gili, I'll look into the best way to achieve this and get back to you tomorrow. Apologies for the delay. -Jason Fauchelle |
|
|
No problem. I took a look into your code today and I have a few ideas. If I figure it out before you reply I'll write here. Thanks!! |
|
|
Managed to get it work (the DiagramBuilder is mine).
|
|
|
Great to hear you've got it working! |
|